Instructions for Replacing 1st Gen Barcode Scanner with 2nd Gen Barcode Scanner

1. Replace Scanner

  1. Disconnect power from terminal – Terminal must be powered off before replacing scanner
  2. Remove scanner from Elo device
  3. Install new scanner

2. Scan “QR Code Scanning OFF” Barcode

  1. Turn terminal back on
  2. Click “Click to Start Scanning” button
  3. Scan below barcode (you will hear a beep when it is successfully scanned) – If you are scanning the barcode image from your phone, make sure your phone’s brightness is set to Max
Skip to content