Instructions for Replacing eDynamo Card Reader with DynaFlex Card Reader
1. Replace Reader
- Disconnect power from terminal – Terminal must be powered off before replacing reader
- Remove eDynamo card reader from Elo device
- Plug USB-C connector of USB cable into USB-C slot on back of DynaFlex card reader
- Place MagTek DynaFlex card reader on top of short lowered section (has a hole for the USB-C cable to pass through) of reader bracket & fasten it using included 4 screws (included with bracket), such that card insert & swipe slots are towards outer edge of bracket – Ensure that card reader is oriented correctly, else on-screen instructions for inserting & swiping a card will be incorrect; Tap should be towards the long section of the bracket, and the Insert slot should be towards the outer edge
- Plug other connector of USB cable into USB slot on back of Elo device – If USB slot on Elo device was being used for Bluetooth beacon, remove & plug beacon into available electrical outlet (one that is hidden from users, so it isn’t accidentally or intentionally unplugged) using a wall charger
- Remove bottom 2 screws & loosen top 2 screws that fasten Elo device to stand
- Place long section of reader bracket in between mounting plate of stand & Elo device, such that top of card reader & screen of Elo device are facing in same direction, and use all 4 screws to fasten Elo device & reader bracket to stand
2. Test Purchase Flow
- Connect device to AC power, and allow it to boot up – usually takes 1-2 minutes
- Click “Click to Start Scanning”
- Scan 1 or 2 products
- Check out & pay